# Steps to Clean and Check Your Manual Mill

> Steps to Clean and Check Your Manual Mill   not electric mills  Please follow the steps below to properly clean and inspect your mill      Remove the top of

Source: https://support.peugeotmillsaustralia.com.au/en_us/steps-to-clean-and-check-your-manual-mill-rkuVkqcx

Last updated: 2025-12-01T04:03:23.176Z

****Steps to Clean and Check Your Manual Mill:**** (not electric mills)

Please follow the steps below to properly clean and inspect your mill:

1.  ****Remove the top of the mill**** and wipe around the neck to ensure there are no salt or pepper granules lodged between the top and the body of the mill.
    
2.  ****Empty the contents of the mill**** and use a pastry brush (or similar soft brush) to clean around the grinding mechanism, gently removing any salt or pepper dust and debris.
    
3.  ****With the top removed, manually rotate the centre shaft**** using your finger to ensure the mechanism is turning freely and functioning correctly.
    
4.  ****Refill the mill****, but do not fill it to the top—approximately ¾ full is recommended to allow proper operation. \*\*NB-\*\*****In Australia, due to the hot and humid temperatures, we recommend you only use dry, white rock salt in Peugeot Salt Mills.****
    
5.  ****Test the mill**** by operating it across all grind settings to ensure it is functioning correctly on each graduation from fine to coarse.
    

****U’Select Mills****

If you find it difficult to turn the adjuster on the U’Select from coarse to fine, to ease this, try doing a quick grind while the setting is still on coarse with the mechanism facing upwards— this will help move the larger salt particles through the mechanism.  After this, it should be easier to turn the adjuster to the fine setting.  
  
Still stuck? Please [reach out](https://support.peugeotmillsaustralia.com.au/contact/peugeot-mills-contact-form-rkVEmwFlWg) to us.
